Differences

This shows you the differences between two versions of the page.

--- operating [2025/02/18 21:17] – [Adding Effects] msebborn
+++ operating [2026/04/24 10:32] (current) – [Adding Effects] msebborn
@@ Line 18: / Line 18: @@
 Connect the inputs to the X32 Desk / S16 Snake, plus main and monitor speakers.  [[suggestedSetup|Suggested Setup]]
+Set the master volume - on Panel B marked MAIN
 ==== Display setup ====
@@ Line 59: / Line 60: @@
 |4|Adjust the Gain using the Gain Knob to get the required input level (a) - do this either by ear or using the input meter on the display| |
 |5|Repeat for all other inputs| |
+Note: During this stage, you can select which channels need Phantom Power - press the 48V button to switch it on (button illuminates when on).
+The "O" button is used to invert the phase of a microphone - this is only really necessary when two mics are picking up the same item, and one mic is out of phase causing the sound to be reduced.
 ==== EQ Settings ====
@@ Line 88: / Line 93: @@
 To add an effect to a channel:
-  - Select the channel to apply the effect to
+|Select the channel to apply the effect to| |
-  - Adjust the Bus Sends 13 & 14 which are predefined with effects (14 has Reverb)
+|On the Bus Sends area, select the 13-16 bank by pressing the lowest button \\ Note: 9-12 is shown selected in the image|{{::bus_sends.jpg?300|}} |
+|Adjust the Bus Sends 13 & 14 which are predefined with effects (14 has Reverb) - these are the 2 lower knobs| |
 Note: add a Mute button to Bus Sends Ch 13 & Ch 14 to switch off effect, by:
@@ Line 98: / Line 104: @@
   * Unselect the "Mute Group" button
+==== Setting the Monitor Mix ====
+Enable the MixBus channels that are to be used for monitors - in panel B set the volume level for used MixBus channel.  Configure the display as required.
+Then select the Input channel on panel A and then using the Bus Sends panel, dial in the amount of sound to be sent to each of the monitors, eg channel 1 (microphone), dial lots into the performers own monitor and some to suit into the other monitor channels.
@@ Line 106: / Line 118: @@
 ==== Things that may turn up ====
-|Adjusting monitor mix| |
+|Adjusting monitor mix|This is done in a similar manner to the effects, except select the Bus Masters 1-4; select the channel and then turn the knobs which are then used to dial the channel into the monitor mix bus.|
 |Adjusting the performance mix| |